Hotbrick VPN 800/8 F User Manual download pdf (Page 11)

HotBrick, Tel: 305

398

0888, Fax: 305

398

5966

2: Quick Installation

Overview

Initial Basic Setup of your VPN800/8 F Firewall involves the following steps:

1. Attach a PC to the VPN800/8 F Firewall in port 3 ~ 14, and configure your LAN.

2. Install your VPN 800/8 F Firewall in your LAN, and connect the Broadband Modem or

Modems.

3. Configure your VPN800/8 F Firewall for Internet Access.

4. Configure PCs on your LAN to use the Drewall.

Requirements

 1 or up to 8 WAN connections, each with an active Internet Access account with an ISP.

 Network cables. Use standard 10/100BaseT network (UTP) cables with RJ45 connectors.



TCP/IP network protocol must be installed on all PCs.

Procedure

1: Configuring the Dual WAN VPN Firewall for your LAN

1. Use a standard LAN cable to connect your PC to any LAN port (Default LAN ports 3 -14) on the

VPN800/8 F Firewall. (Default 2 WAN ports from port 1 – 2)

2. Connect the power cord into a power outlet on the rear panel of VPN800/8 F Firewall.

3. Start your PC. If your PC is already running, restart it. It will then obtain an IP address from the

VPN800/8 F Firewall.

4. Start your WEB browser.

5. In the Address or Location box enter: HTTP://192.168.1.1

6. You will be prompted for the User Name and password, as shown below.

Figure 2-1: Password Dialog

Enter admin for the "User Name" and leave the "Password" blank.



The "User Name" is always admin.



You can and should set a password, using the following Admin Password screen.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 76 77

No comments

Hotbrick VPN 800/8 F User Manual Page 11